Fujitsu Siemens Computers E-6555 - Manual (Page 6)

6
L i f e B o o k E S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: ■ Auto
■ None
■ CD-ROM
■ SuperDisk
■ Hard Disk
[Auto] Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive.
Cylinders: ■ A number
between 0
and 65,535
–— This item appears only when Hard Disk is selected as the type. This
field is changed by incrementing (pressing the [Spacebar]) or by
typing in the number.
Heads: ■ A number
between 1
and 16
–— This item appears only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
Sectors: ■ A number
between 0
and 63
–— This item appears only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu -/Space
Enter F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [FUJITSU MHH2064AT-(PM)]
Type: Auto ]
Maximum Capacity: 20004MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
PIO Transfer Mode: [Fast PIO 4]
DMA Transfer Mode: [Ultra DMA 4]
▲