Fitness Quest 386da - Manual (Page 6)

6
ASSEMBLY
FIGURE 3
Step 5. Slide PEDAL BUSHING (8) onto
SHAFTS of PEDALS (9 RIGHT and
10 LEFT) as shown.
Step 6. Thread SHAFTS of PEDALS (9 & 10)
into CRANK (11) until tight, then back
off 1/2 turn.
Step 7. Thread PEDAL LOCK NUT (12) onto
end of SHAFT. Hold SHAFT with
(additional wrench) and tighten
PEDAL LOCK NUT with other wrench
until tight.
NOTE: PEDAL BUSHING (8) must be able
to spin freely after tightening.
FIGURE 3
FIGURE 4
Step 8. Turn LOCKING KNOB (15)
counterclockwise to loosen.
Step 9. Pull LOCKING KNOB (15) out and raise
SEAT POST (14) to desired SEAT (13)
height and release LOCKING KNOB so
that it snaps into hole in SEAT POST
then turn clockwise until tight.
IMPORTANT
LOCKING KNOB MUST be locked tightly
before you sit on the SEAT.
FIGURE 4
9
RIGHT
PEDAL
SHAFT
11
CRANK
8
PEDAL
BUSHING
12
PEDAL
LOCK NUT
PULL
NUT
14
SEAT
POST
13
SEAT
15
LOCKING
KNOB
WASHER
Step 10. Remove NUTS and WASHERS from
SEAT (13) and attach SEAT to SEAT
POST (14) with NUTS and WASHERS.