Fisher & Paykel GC912 - Manual (Page 9)

Auto re-ignition
Auto re-ignition is for your convenience and safety. The auto re-ignition feature causes the
igniters to spark automatically and the burner to re-light if a flame blows out or if the flame is
severely distorted by a draft or a cooktop ventilation system.
Constant sparking
The igniters must be kept clean and dry to
work correctly. Dirty or wet igniters could
cause constant sparking, even if a flame
is present. (See Troubleshooting guide).
If the burner has an inconsistent flame or does not light
If the gas does not light within four seconds, turn the knob to OFF. Allow at least two minutes
for the gas to disperse before trying again.
Check that the power to the product is switched on.
Check that the burner parts are assembled correctly as below:
Power failure
In the event of a power failure, turn all burner control knobs to OFF. The burners can be lit by
holding a lighted match close to the side of the burner and turning the control knob to HI. Wait
until the flame is burning all the way around the burner cap before adjusting.
EN
Correct assembly Incorrect assembly
Igniters can be kept clean
with a small brush and
rubbing alcohol.
7