FUJITSU M3099GH - Manual (Page 80)

7-9
Setting pick speed
1 In Screen 2, press Mode 1 7 times to
display PICK SPEED SET screen.
<Screen 22>
2 Press Mode 2 to display Screen 23. (The
default setting is “FAST”.)
If “FAST” is displayed, the pick speed is
fast. If “SLOW” is displayed, the pick
speed is slow.
Each time
Mode 1 is pressed, “FAST”
and “SLOW” appear alternately. The
setting is stored in EEPROM automati-
cally.
3 Press Mode 2 to return to Screen 22.
When you close the setup mode, press
Stop .
When you set the pick speed, you must set as follows:
<Screen 22>
(Blinking)
P I K E S P S E C T E D
F A S T S L O W
<Screen 23>
Setting initial value of endorser
Before setting, see page 6-2, “Chapter 6 ENDORSER, Panel Operation”.
• The use of Endorser (ON/OFF)
The default setting is “OFF” (Endorser is not used.)
• The initial number
The default setting is “00000”.
The selectable range is from 00000 to 65535.
NOTE
If the specified value is equal or grater than 65536, returning to SETUP menu will be failed.
< > < > S E T U P M O D E
P I K E S P S E C T E D
15-Chap. (7) 98.2.20, 10:57 AM 9