Fisher FVH-T610 - Manual (Page 9)

MULTIBRAND UNIVERSAL REMOTE CONTROL
Battery Installation and Operation
1 Install the two supplied AA batteries as shown.
2 Aim the remote control at the VCR and press the
desired buttons to operate.
IMPORTANT NOTE:
SPENT OR DISCHARGED BATTERIES MUST BE
RECYCLED OR DISPOSED OF IN A SAFE
MANNER IN COMPLIANCE WITH ALL
APPLICABLE LAWS.
FOR DETAILED INFORMATION, CONTACT YOUR
LOCAL COUNTY SOLID WASTE AUTHORITY.
NOTES:
œ The remote control will not operate properly if
something comes between the VCR and the remote
control.
œ The POWER, 0 – 9, 100/ENTER, INPUT and
CH/TRACK
l and j buttons are used to operate the
VCR, TV, cable box and DSS receiver.
œ VOLUME buttons operate TV volume regardless of the
remote control mode selected.
Setting the remote control code
The multibrand universal remote control can operate the
basic functions of TVs and cable (CATV)
converters/decoders made by the manufacturers listed
below.
To enter the remote control code for your brand of TV or
cable converter/decoder, follow the steps below.
For TV operation
1 In the chart below, find the code corresponding to
your brand of TV.
2 While holding down the TV button, enter the 2-digit
code using the number buttons (0 – 9).
The remote control is now set to operate your TV.
TV brands Code
ADMIRAL 05, 10, 13
EMERSON 17
FISHER 03
GE 07
GOLDSTAR 01
HITACHI 02
JVC 15
MAGNAVOX 08
MATSUSHITA 12, 18
MITSUBISHI 14
PANASONIC 12, 18
QUASAR 12, 18
RCA 06
SAMSUNG 16
SANYO 03
SHARP 00, 13
SONY 11
TECHNOL ACE 05
TOSHIBA 04
ZENITH 09, 10
NOTE: There may be some older TV models that
cannot be operated with this remote control. If this is
the case, use the original remote control supplied with
the TV.
Using the remote control
1 Before using the remote control, press the VCR,
TV or CATV/DSS button to select the device to be
operated.
2 To switch the remote control mode (to operate a
different device), be sure to press the VCR, TV or
CATV/DSS button first.
SC4H/UF (FVH-T610 GB) Fri. Jan., 07/2000
8