FujiFilm MP-300 - Manual (Page 13)

24 25
Printing Printing
2 2 Precautions during data transfer
z Do not place objects between the sending device and the printer.
z Leaving the printer in direct sunlight or directly under fl uorescent lighting may
prevent data transfer.
z The sending device and printer may be unable to communicate successfully
if they are close to equipment that generates interference or close to other
infrared communications devices such as remote controls for TVs or VCRs.
z Do not move the sending devise’s infrared port or the printers infrared receptor
until data transfer ends.
Lit Lit
Hold down the POWER button (one
second or more) to turn the printer on.
x The POWER button lights.
x If you leave the printer on, it automatically
turns off (after 3 minutes when using
batteries and after 10 minutes when
using the AC power adapter).
Check the fi lm counter to ensure that a
fi lm remains in the printer.
Turning on the power.
15 °
15 °
20cm (7.9 in.)
Point the infrared port on the sending
device directly at the printer’s infrared
port. (P.27)
x Images can be transmitted up to 20
cm (7.9 in.) at an angle of up to 15˚
up, down, left or right.
Align the infrared ports.
PRINTING - Infrared communication -
Setting up for infrared transmissions
On the sending device, select
the image to be printed.
Printing
(P.26)
1 1
2 2
When the printer is connected to a digital camera (when the PictBridge
lamp is lit), images cannot be printed using infrared communication. To
use infrared communication to print, first disconnect the USB cable.
4 4 Notes on taking out film
z Never pull the fi lm out before the printer has fi nished feeding the fi lm out.
z Grip the leading edge of the fi lm and pull it straight out, taking care not to bend
the fi lm.
z Always take the print out when printing is complete.
Lit (POWER button)
Slow Blinking (POWER button)
x The POWER button blinks slowly
during image transfer.
x See P.26 for information on infrared
transmission from a mobile phone.
Send the image from the sending
device using infrared communication.
Take the print out when the POWER
button stops blinking and stays lit.
x When the POWER button stops
blinking and stays lit, the next image
can be transferred.
Take the film out when film
output ends.
Rapid Blinking (POWER button)
x The POWER button blinks rapidly
during printing.
x Printing of a VGA-size (FUJIFILM
standard) image takes 20 seconds
once the infrared signal is received.
x Printing may take longer for images
larger than VGA-size.
The film is fed out roughly 20 seconds
after the printer receives the image.
3 3
4 4