FujiFilm MP-300 - Manual (Page 15)

28 29
Printing Printing
x For information on using your digital
camera, refer to the owner’s manual
supplied with the camera.
On some digital camera models, the digital camera should be turned off
at this point. Because the transmission method varies depending on the
model used, check the owner’s manual for your digital camera.
PRINTING - PictBridge -
Setting up for USB transmissions
Select PictBridge in the digital
camera’s USB setting.
x When the printer and the digital camera
are correctly connected, the PictBridge
lamp will light after MP-300 power on.
x Use the USB cable supplied with
the digital camera. Do not use an
extension cable or USB hub.
x The location of the USB socket varies
depending on the digital camera used.
Connect the digital camera to the
printer.
Lit Lit Hold down the POWER button (one
second or more) to turn the printer on.
x The POWER button lights.
x If you leave the printer on, it automatically
turns off (after 3 minutes when using
batteries and after 10 minutes when
using the AC power adapter).
Check the fi lm counter to ensure that
there is still fi lm in the printer.
Turning on the power.
Printing
P I C T B R I D G E P I C T B R I D G E
ENGLISH ENGLISH
SET
SET
NTSC NTSC
1
3
2
OK OK
1 1
Select the image on the digital
camera and then print the image.
The film is fed out roughly 20 seconds
after the printer receives the image.
Lit (POWER button)
Lit (PictBridge lamp)
Take the print out when the POWER
button stops blinking and stays lit.
x When the POWER button stops
blinking and stays lit, the next image
can be transferred.
x See “Notes on taking out fi lm”. (P.25)
Take the film out when film
output ends.
Blinking Lit
x The POWER button blinks slowly
during image transfer.
x For information on using your digital
camera, refer to the owner’s manual
supplied with the camera.
x If multiple prints have been specifi ed,
refer to P.31.
Rapid Blinking (POWER button)
Lit (PictBridge lamp) x The POWER button blinks rapidly
during printing.
x Printing of a VGA-size (FUJIFILM
standard) image takes 20 seconds
once the infrared signal is received.
x Printing may take longer for images
larger than VGA-size.
2 2
3 3
On some digital camera models, the digital camera should be turned on
at this point. Check the owner’s manual for your digital camera.