Fostex HP-P1 - Manual (Page 9)

E-9
Setting the filter
You can select the digital filter type using the [FIL-
TER] switch depending on your preference.
There are two switch positions; “1” and “2”.
1: Conventional digital filter called “sharp roll-off
filter”.
2: AKM’s newly developed digital filter called “mini-
mum delay filter”. It accurately reproduces the
original recorded sound without pre-echo.
<Memo>:The [FILTER] switch only affects the
headphone output. It does not affect the [LINE
OUT] jack.
Specifications
• Headphone output jack (stereo mini jack)
Maximum output power: 80 mW + 80 mW
Applicable load impedance: 16 ohms or more
Frequency response: 20 Hz to 20 kHz +/- 0.3
dB (at 32 ohm load, 80 mW output power)
• [LINE OUT] jack (stereo mini jack)
Nominal output level: -10 dBV
• Analog input jack (stereo mini jack)
Maximum input: Approx. 3.0 Vrms
• [S/PDIF] output jack (optical)
S/PDIF format (IEC 60958-3)
• USB connector (type A) for Dock Connector to
USB cable
For iPod/iPhone connection
USB Type A
• [DC-IN] port
USB Type mini B
• Power supply
Internal lithium-ion battery
• External dimensions
75 (width) x 25 (height, excluding rubber feet) x
130 (depth, including protrusions) mm
• Weight: Approx. 260 g
* “Made for iPod” and “Made for iPhone,” mean
that an electronic accessory has been designed
to connect specifically to iPod and iPhone,
respectively, and has been certified by the de-
veloper to meet Apple performance standards.
Apple is not responsible for the operation of this
device or its compliance with safety and regula-
tory standards. Please note that the use of this
accessory with iPod, iPhone, may affect wireless
performance.
* iPhone, iPod, iPod classic, iPod nano, iPod shuf-
fle, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
* Specifications and appearance are subject to
change without notice for product improvement.