Unpacking the imager, Charging the battery, Turning the imager on and off – Fluke Thermal Imagers Ti10 User Manual
Page 9: Features and controls
Thermal
Imagers
Unpacking the Imager
3
Unpacking the Imager
Carefully unpack the following items:
•
Ti10, Ti25, TiR or TiR1 Imager
•
AC Power Adapter/Charger
•
Rugged Carrying Case
•
SD Memory Card
•
SD Card Reader
•
Soft Transport Bag
•
User Manuals (in various languages)
•
SmartView™ Software
•
Warranty Registration Card
Charging the Battery
Before using the Imager for the first time, charge the battery for at least two
hours. The Imager’s battery condition is displayed in the upper-left corner of
the display. When the last segment of the battery icon extinguishes, the Imager
will shut down and will require recharging before operating again. To charge
the Imager’s battery:
1.
Plug the ac input of the battery charger into an ac wall outlet.
2.
Plug the battery charger’s dc output into the Imagers ac adapter socket.
The optional Car Charger can also be used to recharge the Imager’s battery.
While the battery is charging, the battery icon appears as
A while the
Imager is operating. With the Imager off,
b appears in the display while
connected to the battery charger.
Turning the Imager On and Off
To turn the Imager on or off, press the center softkey (
a) for two seconds.
Features and Controls
Imager features and controls are shown and described in Table 2.