Fluke Thermal Imagers Ti10 - Manual (Page 21)

Thermal Imagers
Changing the SD Card
15
Changing the SD Card
To eject an SD card from the Imager, press in on the exposed edge of the SD
card and then release. The card should pop partially out after releasing it.
Carefully pull the card out of the slot.
Note
The SD Card can be inserted and removed while the Imager is in
operation.
To insert an SD card into the Imager, carefully slip the card into the slot with
the card’s label facing toward the LCD display. Push the card in until it
catches.
Setting the Backlight
The backlight can be set to Auto-sensing or Full-Bright. To set the backlight:
1. Press a until Backlight appears over c.
2. Press the softkey labeled Backlight .
3. Press the softkey labeled Auto or Full-Bright .
Note
To extend battery life, Auto-Sensing automatically adjusts backlight
brightness based on ambient light levels.
General Specifications
Temperature
Operating........................................................... -10
°
C to 50
°
C (14
°
F to 122
°
F)
Storage.............................................................. -20
°
C to +50
°
C (-4
°
F to 122
°
F)
without batteries
Relative Humidity................................................. 10 to 90 % non-condensing
Display.................................................................. 640 x 480 color LCD, approx. 2” X 3”
(Landscape orientation)
with Backlight (selectable Bright or
Auto)
Controls and Adjustments
User selectable temperature scale (
°
C/
°
F)
Language selection
Time/Date set
Emissivity selection (Ti25 and TiR1 only)
User selectable Hot Spot and Cold Spot on the image (TiR1 and Ti25 only)