Fujitsu Siemens Computers 21P4 - Manual (Page 11)

Colour monitor 21P4
A26361-K886-Z100-1-5E19 English - 9
Ê Connect one of the connectors of the data cable to the D-SUB connector on the monitor (2)
and secure the plug-in connection by tightening the safety screws.
i
If you use a data cable with BNC connectors instead of the supplied data cable, you
should perform the following step:
Ê Connect the BNC connectors of the data cable to the appropriate BNC connectors
on the monitor (3), correct order from left to right: Red-Green-Blue-H-V, and secure
the plug-in connections by locking the bayonet catches.
Ê Change the video signal in the OSD menu (function D-SUB/BNC ).
Ê Connect the 15-pin connector of the data cable to the (active) monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
i
If your computer has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is usually active.
Ê Plug the power cable supplied into the power connector of the monitor.
Ê Plug the power connector of the computer into a properly grounded mains outlet.
i
When you start working with your monitor for the first time you should install the
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your graphics card/the associated driver software.
Operation of the monitor
1
2 3
1 = Buttons for the OSD menu
(On-Screen-Display)
2 = Power indicator
3 = Power button