5 scsi-id setting, Scsi -id setting -6, Scsi-id setting -6 – FUJITSU M3096EX User Manual
Page 27: Scsi-id setting
Advertising
3 – 6
3.5
SCSI-ID Setting
Use the address switches to set the device address. After the setting
turn the scanner on.
Address switch
Figure 3.1 SCSI-ID setting
* When the scanner is terminated device, the termination connector
must be connected on one side of the connectors.
Table 3.1 SCSI-ID setting
ID
0 to 7
8, 9
Contents
Available
No Operation
Advertising
This manual is related to the following products: