FUJITSU T5440 - Manual (Page 146)

124 SPARC Enterprise T5440 Server Service Manual • June 2011
■ “Power On the Server” on page 157
Servicing the Service Processor
The service processor module contains the service processor firmware, IDPROM, and
system battery.
■ “Remove the Service Processor” on page 124
■ “Install the Service Processor” on page 126
Related Information
■ “Servicing the IDPROM” on page 127
■ “Servicing the Battery” on page 129
▼ Remove the Service Processor
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 63 .
■ Power off the server using one of the methods described in the section, “Powering
Off the System” on page 67 .
■ “Extend the Server to the Maintenance Position” on page 70
■ “Disconnect Power Cords From the Server” on page 68
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 73
■ “Remove the Top Cover” on page 73
Do the following:
1. Ensure that the power cords are disconnected from the server.
2. Loosen the two captive No. 2 Phillips screws securing the service processor to
the motherboard.