Controlíbuttons – FRIGIDAIRE RH36WC60GS User Manual
Page 16
16
Controlíbuttons
Controlíbuttons
This hood is equipped with an electronic motor and
lamp control.
ON/OFF light and has a timer function.
In the following drawing are described the main key
functions.
1.íLightíButton
1.íLightíButton
1.íLightíButton
1.íLightíButton
1.íLightíButton
Press lamp button to turn ON the light ôLamp
state previously OFFÈ.
Press lamp button to turn OFF the light ôLamp
state previously ONÈ.
2.íTimeríButton
2.íTimeríButton
2.íTimeríButton
2.íTimeríButton
2.íTimeríButton
The default timer setting is êû minutes, and it
can be adjusted between 2û minutes and
êminute.
After pressing the timer button, the control
enters to a timer setup mode, and user can
adjust the timer countdown time with the
“
” and “
” buttons within 5 seconds.
The timer can be initiated immediately
pressing the timer button, after setting the
timer duration or pressing the timer button
twice ôdefault êû minutes settingÈ.
If no action occurs within 5 seconds, the
countdown will start.
During the timer setup the “
” and “
”
buttons are dedicated to the timer and no
motor action will occur.
Once the timer is initiated, it can be cancelled
by pressing the timer button again.
3.íDisplay
3.íDisplay
3.íDisplay
3.íDisplay
3.íDisplay
Shows the hood settings.
4.н“
4.н“
4.н“
4.н“
4.н“
”íButton.íSpeedíDecr
”íButton.íSpeedíDecr
”íButton.íSpeedíDecr
”íButton.íSpeedíDecr
”íButton.íSpeedíDecreaseí/íOFF
easeí/íOFF
easeí/íOFF
easeí/íOFF
easeí/íOFF
This button is used to decrease the fan speed,
or turn OFF the fan.
The fan will turn OFF if the “
” button is
If the fan is at second speed and the “
”
speed.
If the fan is at third speed and the “
” key is
pressed, the fan will be set to second speed.
If the fan is at fourth speed and the “
”
button is pressed, the fan will be set to third
speed.
If the fan is OFF and the “
” button is
pressed, the control backlight will light up.
5.н“
5.н“
5.н“
5.н“
5.н“
”íButton.íSpeedíIncr
”íButton.íSpeedíIncr
”íButton.íSpeedíIncr
”íButton.íSpeedíIncr
”íButton.íSpeedíIncreaseí/íON
easeí/íON
easeí/íON
easeí/íON
easeí/íON
This button is used to increase the fan speed,
or turn ON the fan.
The fan will turn ON if the “
” button is
pressed and the hood was OFF.
” button
is pressed, the fan will be set to second
speed.
If the fan is at second speed and the “
”
button is pressed, the fan will be set to third
speed.
If the fan is at third speed and the “
”
button is pressed, the fan will be set to fourth
speed.
If the fan is at fourth speed and the “
”
button is pressed, a beep will sound.