First Alert 2.5Color LCD Portable Wireless Family Monitor DWB-740 - Manual (Page 20)

20
T r o u b l e s h o o t i n g
Problem Possible Causes Remedies
System message
shows “No Signal” No power supply to
camera Check power adapter and power cable
connection. If camera is running on
battery alone, you may need to replace
batteries.
Camera is not paired
with receiver See pairing operation for detail .
Service out of range Move the camera closer to the receiver.
Signal is blocked If possible, remove major obstacles in
between the camera and the receiver. Or,
relocate the camera to another location.
Low or unstable
signal Antenna direction is
limited Adjust the camera antenna and receiver
position.
Signal has been
blocked If possible, remove major obstacles in
between the camera and receiver. Or,
relocate the camera to another location.
Strong radio signal
nearby Keep WIFI router away from the camera
and/or receiver.
Strong electromagnetic
interference nearby Keep active appliances such as hair
dryers, heat fans, air conditioners, water
pumps, or microwave ovens away from
the camera and/or receiver.
Recording does not
work No SD Card Insert SD Card.
SD Card locked Unlock the SD Card.
Black screen
& Buttons
no function Power save mode on Press power key to resume receiver
image; please refer to [Power Saving]
section on page 12 for details.
Audio feedback Camera and receiver
are too close The camera has a high sensitivity
microphone. Keep the camera at least 10
feet away from the receiver. If the camera
must be within 10 feet of the receiver,
keep the volume down.
VOX Record & Alarm
does not work VOX Menu set to “OFF” Set VOX Sensitivity/VOX Alarm/VOX Record to
ON
.