Field Controls TYPE "C" - Manual (Page 3)

Page 3
WIRING
1. Remove the four (4) screws that hold the conical rain cover in place.This will expose the motor juction box.
CAUTION: Disconnect electrical power when wiring draft inducer.
2. Wire the draft inducer in accordance with the National Electrical Code and applicable local codes. UNIT MUST BE
GROUNDED! Check ground circuit to make certain the unit has been properly grounded. The wiring should be
protected by an overcurrent protection circuit, such as a fuse or circuit breaker rated at 15 amperes. (See Diagram A)
3. After wiring, replace conical rain cover.
Diagram A