Fostex VR800 - Manual (Page 16)

16
VR800 Quick Operation Guide
Basic recording
After you finish preparing a recording media and connecting a mixer, you can start basic recording
using the VR800.
Initial settings
You need to reset all the controls on the VR800 to their initial settings according to the controls and
switches on the mixer before you proceed to the next step. This procedure is called “Initialize” in
this Guide and in the Owner’s Manual. The button and switches on the VR800 should be reset as
shown below. Remember to “Initialize the VR800” before you start a new session.
Set the RECORD TRACK select keys to
“SAFE.” (The RECORD TRACK select
key lamps turns off.)
Locate the top of the selected
program (ABS 0).
Stop the recorder. (The STOP
button lamp will lights up.)
Turn off AUTO RTN/AUTO PLAY mode.
(Nothing should appear in the AUTO
section on the display.)
STORE key lamp turns off.
Turn off AUTO PUNCH mode.
(Nothing should appear in the A.
PUNCH section on the display.)
SHIFT P.EDIT LOC MEM
RECORD STOP PLAY REW F FWD
AUTO PUNCH
CLIPBOARD AUTO RTN
OUT IN END OUT IN START
EJECT
ACCESS
5 6 7 8
OL
24
12
6
0
1 2 3 4
RECORD TRACK
4 3 2 1 5 6 7 8
EXECUTE
/ YES
EXIT
/ NO
DISP SEL UNDO / REDO EDIT HOLD/ STORE SETUP
JOG
VARI PITCH SCRUB LOCATE AUTO PLAY
PGM SEL
AUTO RTN
TIME BASE SEL SHUTTLE
LOCATE REC END
LOCATE ABS 0
CLIPBOARD PLAY
PUNCH AUTO
OPTICAL
A SYNC
PREVIEW Turn off the Vari-pitch function. ([VARI
PITCH] should not appear on the dis-
play.)
SCRUB key lamp turns off.
About sampling frequency
The VR800 uses a sampling frequency of 44.1kHz. When you record or play back on a VR800 connected to
a digital mixing console, set the sampling frequency of the digital mixer to 44.1kHz. Using a different
sampling frequency on the mixer will prevent normal recording and playback.