FUJITSU MPA3043AT - Manual (Page 30)

C141-E034-02EN 3 - 3
3.2 Mounting
(1) Orientation
Figure 3.2 illustrates the allowable orientations for the disk drive. The mounting angle can vary
±5° from the horizontal.
(a) Horizontal mounting (b) Vertical mounting –1 (c) Vertical mounting –2
Figure 3.2 Orientation
(2) Frame
The disk enclosure (DE) body is connected to signal ground (SG) and the mounting frame is also
connected to signal ground. These are electrically shorted.
Note:
Use No.6-32UNC screw for the mounting screw and the screw length should satisfy the
specification in Figure 3.4.
(3) Limitation of side-mounting
When the disk drive is mounted using the screw holes on both side of the disk drive, use two screw
holes shown in Figure 3.3.
Do not use the center hole. For screw length, see Figure 3.4.
gravity