FUJITSU MCE3130AP User Manual
FUJITSU Hardware
Advertising
Table of contents
Document Outline
- Copyright
- REVISION RECORD
- PREFACE
- CONTENTS
- CHAPTER 1 GENERAL DESCRIPTION
- CHAPTER 2 SPECIFICATIONS
- CHAPTER 3 INSTALLATION REQUIREMENTS
- CHAPTER 4 HOST INTERFACE
- 4.1 Pin Assignment
- 4.2 Signal Description
- 4.3 Interface Registers
- 4.4 Various Processes
- 4.5 ATA Commands
- 4.5.1 IDENTIFY PACKET DEVICE (X'A1')
- 4.5.2 PACKET (X'A0')
- 4.5.3 DEVICE RESET (X'80')
- 4.5.4 CHECK POWER MODE (X'98'/X'E5')
- 4.5.5 EXECUTE DEVICE DIAGNOSTIC (X'90')
- 4.5.6 GET MEDIA STATUS (X'DA')
- 4.5.7 IDLE IMMEDIATE (X'95'/X'E1')
- 4.5.8 NOP (X'00')
- 4.5.9 SERVICE (X'A2') (Not supported)
- 4.5.10 SET FEATURES (X'EF')
- 4.5.11 SLEEP (X'99'/X'E6')
- 4.5.12 STANDBY IMMEDIATE (X'94'/X'E0')
- 4.6 Packet Commands
- 4.6.1 Logical Unit Number
- 4.6.2 ERASE command
- 4.6.3 FORMAT UNIT command
- 4.6.4 INQUIRY command
- 4.6.5 MODE SELECT command
- 4.6.6 MODE SENSE command
- 4.6.7 PREVENT/ALLOW MEDIUM REMOVAL command
- 4.6.8 READ (10) command
- 4.6.9 READ (12) command
- 4.6.10 READ CAPACITY command
- 4.6.11 READ FORMAT CAPACITIES command
- 4.6.12 READ DEFECT DATA command
- 4.6.13 READ LONG command
- 4.6.14 RECEIVE DIAGNOSTIC RESULTS command
- 4.6.15 REQUEST SENSE command
- 4.6.16 SEND DIAGNOSTIC command
- 4.6.17 SEEK command
- 4.6.18 START/STOP UNIT command
- 4.6.19 SYNCHRONIZE CACHE command
- 4.6.20 TEST UNIT READY command
- 4.6.21 VERIFY command
- 4.6.22 WRITE (10) command
- 4.6.23 WRITE (12) command
- 4.6.24 WRITE AND VERIFY command
- 4.6.25 WRITE BUFFER command
- 4.6.26 WRITE LONG command
- 4.7 Timing
- CHAPTER 5 OPERATION AND CLEANING
- CHAPTER 6 DIAGNOSIS AND MAINTENANCE
- Glossary
- Abbreviations
- Index
- Reader Comment Form
- Back Title