Document Outline

• Copyright
• REVISION RECORD
• PREFACE
• CONTENTS
• CHAPTER 1 GENERAL DESCRIPTION
  • 1.1 Features
    • 1.1.1 Performance
    • 1.1.2 Reliability
    • 1.1.3 Maintainability/operability
    • 1.1.4 Adaptability
    • 1.1.5 Interface
  • 1.2 Drive Configuration
    • 1.2.1 Drive model
    • 1.2.2 Configuration
    • 1.2.3 Mechanical sections
    • 1.2.4 Control circuit section
  • 1.3 System Configuration
• CHAPTER 2 SPECIFICATIONS
  • 2.1 Optical Disk Drive Specifications
    • 2.1.1 Model and product number
    • 2.1.2 Drive specifications
    • 2.1.3 Environmental and power requirements
    • 2.1.4 Error rate
    • 2.1.5 Reliability
  • 2.2 Optical Disk Cartridge Specifications
    • 2.2.1 Recommended optical disk cartridge specifications
    • 2.2.2 Optical disk cartridge
    • 2.2.3 Disk specifications
  • 2.3 Defect Management
    • 2.3.1 Defect management schematic diagram
• CHAPTER 3 INSTALLATION REQUIREMENTS
  • 3.1 Environmental Requirements
    • 3.1.1 Temperature measurement point
    • 3.1.2 Temperature requirements and measuring method
    • 3.1.3 Air flow
    • 3.1.4 Temperature rise under several conditions
    • 3.1.5 Air purity
  • 3.2 Mounting Requirements
    • 3.2.1 External dimensions
    • 3.2.2 Installation direction
    • 3.2.3 Centers of gravity
    • 3.2.4 Notes on mounting
  • 3.3 Power Supply Requirements
  • 3.4 Cable Connections
    • 3.4.1 Drive connectors
    • 3.4.2 Cable connector specifications
    • 3.4.3 Drive connection
  • 3.5 Jumper Settings
    • 3.5.1 Jumper settings at factory shipping
    • 3.5.2 Mode setting
  • 3.6 Notes on Drive Handling
  • 3.7 Mounting
    • 3.7.1 Checks before mounting the drive
    • 3.7.2 Mounting procedure
  • 3.8 Cable Connections
  • 3.9 Operation Confirmation and Preparation for Use after Installation
    • 3.9.1 Confirming initial operations
    • 3.9.2 Connection check
  • 3.10 Dismounting Drive
• CHAPTER 4 HOST INTERFACE
  • 4.1 Pin Assignment
  • 4.2 Signal Description
  • 4.3 Interface Registers
    • 4.3.1 I/O registers
  • 4.4 Various Processes
    • 4.4.1 Reset response
    • 4.4.2 Defect sector management
    • 4.4.3 Automatic alternate sector assignment function
    • 4.4.4 Data error detection criteria
    • 4.4.5 Cache function
    • 4.4.6 Media status notification function
    • 4.4.7 Power management function
    • 4.4.8 LED Indications
  • 4.5 ATA Commands
    • 4.5.1 IDENTIFY PACKET DEVICE (X'A1')
    • 4.5.2 PACKET (X'A0')
    • 4.5.3 DEVICE RESET (X'80')
    • 4.5.4 CHECK POWER MODE (X'98'/X'E5')
    • 4.5.5 EXECUTE DEVICE DIAGNOSTIC (X'90')
    • 4.5.6 GET MEDIA STATUS (X'DA')
    • 4.5.7 IDLE IMMEDIATE (X'95'/X'E1')
    • 4.5.8 NOP (X'00')
    • 4.5.9 SERVICE (X'A2') (Not supported)
    • 4.5.10 SET FEATURES (X'EF')
    • 4.5.11 SLEEP (X'99'/X'E6')
    • 4.5.12 STANDBY IMMEDIATE (X'94'/X'E0')
  • 4.6 Packet Commands
    • 4.6.1 Logical Unit Number
    • 4.6.2 ERASE command
    • 4.6.3 FORMAT UNIT command
    • 4.6.4 INQUIRY command
    • 4.6.5 MODE SELECT command
    • 4.6.6 MODE SENSE command
    • 4.6.7 PREVENT/ALLOW MEDIUM REMOVAL command
    • 4.6.8 READ (10) command
    • 4.6.9 READ (12) command
    • 4.6.10 READ CAPACITY command
    • 4.6.11 READ FORMAT CAPACITIES command
    • 4.6.12 READ DEFECT DATA command
    • 4.6.13 READ LONG command
    • 4.6.14 RECEIVE DIAGNOSTIC RESULTS command
    • 4.6.15 REQUEST SENSE command
    • 4.6.16 SEND DIAGNOSTIC command
    • 4.6.17 SEEK command
    • 4.6.18 START/STOP UNIT command
    • 4.6.19 SYNCHRONIZE CACHE command
    • 4.6.20 TEST UNIT READY command
    • 4.6.21 VERIFY command
    • 4.6.22 WRITE (10) command
    • 4.6.23 WRITE (12) command
    • 4.6.24 WRITE AND VERIFY command
    • 4.6.25 WRITE BUFFER command
    • 4.6.26 WRITE LONG command
  • 4.7 Timing
    • 4.7.1 Register/PIO data transfer timing
    • 4.7.2 Multiword DMA data transfer timing
    • 4.7.3 Power-on and Reset Timing
• CHAPTER 5 OPERATION AND CLEANING
  • 5.1 Operating Optical Disk Drive
    • 5.1.1 Optical disk drive
    • 5.1.2 Note
    • 5.1.3 Inserting cartridge
    • 5.1.4 Ejecting (removing) cartridge
  • 5.2 Cleaning Drive
  • 5.3 Optical Disk Cartridge Operation
    • 5.3.1 Optical disk cartridge
    • 5.3.2 Write protect tab
    • 5.3.3 Notes
  • 5.4 Cleaning Optical Disk Cartridge
    • 5.4.1 Cleaning tool
    • 5.4.2 Cleaning procedure
• CHAPTER 6 DIAGNOSIS AND MAINTENANCE
  • 6.1 Diagnosis
    • 6.1.1 Initial self-diagnosis
    • 6.1.2 Diagnostic command
    • 6.1.3 Test program
  • 6.2 Maintenance Information
    • 6.2.1 Maintenance requirements
    • 6.2.2 Revision number
• Glossary
• Abbreviations
• Index
• Reader Comment Form
• Back Title