FRIGIDAIRE 316137234 User Manual

Installation instructions, Over the range microwave oven, 1 mounting space

Advertising
background image

1 MOUNTING

SPACE

This Microwave Oven/Hood requires a mounting space on
a wall as shown in Figure 1. It is designed to be used with
standard 12" wall cabinets.

TINSEB151WRRZ

Printed in Thailand

Backsplash

Figure 1

15.5"

30" or more

from cooking

surface

30"

At least 2"

12"

P/N 316137234

NEED HELP?

For customers in the United States, call: 1-800-944-9044

For customers in Canada, call: 1-800-213-9397 (English)

1-800-668-4606 ext.8199 (French)

READ CAREFULLY. KEEP THESE INSTRUCTIONS.

BEFORE YOU BEGIN

IMPORTANT

Save these instructions for local

inspector’s use.

IMPORTANT

Observe all governing codes and

coordinates.

NOTE TO INSTALLER

– Be sure to leave these

instructions with the Consumer.

NOTE TO CONSUMER

– Keep these instructions for

future reference.

SKILL LEVEL

– Installation of this appliance requires

basic mechanical and electrical skills.

• Proper installation is the responsibility of the installer.

• Product failure due to improper installation is not covered

under the Warranty.

• Please read all instructions thoroughly before installing

the Over the Range Microwave Oven. Two people are
recommended to install this product.

• If a new electrical outlet is required, its installation should be

completed by a qualifi ed electrician before the Microwave
Oven is installed. See 3 ELECTRICAL GROUNDING
INSTRUCTIONS
on page 2.

Read these instructions completely and carefully.

INSTALLATION INSTRUCTIONS

Over The Range Microwave Oven

2 WALL

CONSTRUCTION

This Microwave Oven/Hood should be mounted against and
supported by a fl at vertical wall. The wall must be fl at for
proper installation. If the wall is not fl at, use spacers to fi ll in
the gaps. Wall construction should be a minimum of 2" x 4"
wood studding and

³⁄₈" or more thick dry wall or plaster/lath.

The mounting surfaces must be capable of supporting weight
of 110 pounds—the oven and contents—AND the weight of
all items which would normally be stored in the top cabinet
above the unit.

The unit should be attached to a minimum of one 2" x 4"
wall stud or two 2" x 3" wall studs.

To fi nd the location of the studs, one of the following methods
may be used:

A. Use a stud finder, a magnetic device which locates the

nails in the stud.

B. Use a hammer to tap lightly across the mounting surface

to find a solid sound. This will indicate stud location.

The center of the stud can be located by probing the wall with
a small nail to fi nd the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.

66" or more

from floor

Advertising