FireplaceXtrordinair 864 HH - Manual (Page 6)

6 Operation
© Travis Industries 4080218 100-01181_003
Before You Begin
•
Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.
Location of Controls
Lift the control cover up and swing it
forward to access the controls.
Pilot Igniter
ON/OFF Switch
Flame Adjust Knob Gas Control Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
The Pilot Flame can be
found under the right side log
.
Comfort Control
Gas Control Valve
Optional Blower Control
Optional Accent Light
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark
directly next to the pilot, igniting the pilot flame.
On/Off Switch This control is used to turn the fireplace burners on and off.
Gas Control Knob This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
Blower Control This knob controls the speed of the internal convection blower that
pushes heated air into the room.
Optional Accent Light This knob controls the optional accent lights located behind the logs.