Furuno 1932 MARK-2 - Manual (Page 5)

iii
TABLE OF CONTENTS
SYSTEM CONFIGURATION ............................................................. iv
EQUIPMENTS LIST ............................................................................ v
1. MOUNTING
1.1 Mounting Methods for Scanner Unit .................................................................. 1-1
1.2 Fixing Holes in Mounting Platform .................................................................... 1-1
1.3 Fastning the Radiator to the Radiator Bracket .................................................. 1-2
1.4 Mounting the Scanner Unit ................................................................................ 1-2
1.5 Display Unit Mounting ....................................................................................... 1-4
2. CONNECTIONS
2.1 Connecting the Signal Cable ............................................................................. 2-1
2.2 Display Unit Connections .................................................................................. 2-2
2.3 Connection of External Equipment .................................................................... 2-3
2.4 Exchange of Fuse for 24/32V Power Supply ..................................................... 2-4
2.5 Checking the Installation ................................................................................... 2-4
3. ADJUSTMENTS
3.1 Preparation........................................................................................................ 3-1
3.2 Adjusting Tuning/Video ...................................................................................... 3-1
3.3 Entering Antenna Height ................................................................................... 3-1
3.4 Aligning Heading ............................................................................................... 3-2
3.5 Adjusting Sweep Timing .................................................................................... 3-2
3.6 Adjusting MBS ................................................................................................... 3-3
3.7 Selecting STC Curve ......................................................................................... 3-3
3.8 Setting Dead Sector .......................................................................................... 3-3
3.9 Checking Magnetron Heater Voltage ................................................................ 3-4
4. INSTALLATION OF ARP-10 (OPTION)
4.1 Necessary Parts ................................................................................................ 4-1
4.2 Mounting ........................................................................................................... 4-1
4.3 Adjustments ....................................................................................................... 4-1
INSTALLATION MATERIALS, ACCESORIES, SPARE PARTS ..... A-1
OUTLINE DRAWING ...................................................................... D-1
SCHEMATIC DIAGRAM ................................................................. S-1