Furman Sound SPB-8/8E - Manual (Page 2)

F u r m a n S o u n d , L L C • 1 6 9 0 C o r p o r a t e C i r c l e • P e t a l u m a , C A 9 4 9 5 4 - 6 9 1 9
P h o n e : 7 0 7 . 7 6 3 . 1 0 1 0 • F a x : 7 0 7 . 7 6 3 . 1 3 1 0 • w w w. f u r m a n s o u n d . c o m
Powering your pedals, amps and other gear,
the SPB-8 offers two levels of surge and short
circuit protection, as well as RF and EMI filtering.
Furman’s SPB-8 is quiet, powering both AC and DC
pedals without hum, due to the high quality toroidal
transformer employed. Each DC output is rated
at 100 mA, as well as being individually protected
against shorts — guaranteeing that if one pedal
goes out, the rest are protected and continue to
function.
The SPB-8 makes pack-up simple and
convenient. Unpatching several effects boxes and
pedals is no longer required, since the large Velcro
sheet and included mating strips firmly secures
all of your pedals in place. A sturdy, padded case
is included and comes with a shoulder strap and
zippered pouches for storing cables, wall warts, and
AC cords.
10 FOOT AC POWER
CORD
15 Amp BREAKER
AC OUTLETS WITH RFI/EMI
and SURGE SUPPRESSION
THREE YEAR LIMITED WARRANTY
The Furman PL-8 and PL-PLUS are protected
by a limited three-year warranty covering defects in
materials and workmanship.
OPTION

Model SPB-8 E: “E” suffix versions are for use
in countries with 220/240 volt AC lines.
SPB-8/8E SPECIFICATIONS
POWER CONDITIONING
Current Rating: 15 Amps total AC outlets (10
Amps “E” version)
Spike Protection: Line to Neutral
Spike Clamping Voltage: Initial turn-on at 200 Volts;
TVSS rating of 400 Volts peak
at 500 Amps (“E” version
initial turn-on is 390 Volts
peak)
Response Time: 1 nanosecond
Maximum Surge Current: 6,500 Amps
Maximum Spike Energy: 80 Joules (“E” version 130
Joules)
Noise Attenuation: Transverse mode - greater
than 20 dB, 800 kHz to 10
MHz
9 VDC SUPPLY
Current Rating: 100 mA.per outlet, 1A
maximum combined current
for all outlets
Protection: (8) discrete PTC
automatically resettable
fuses.
Fuse trip time: 0.2 second for 1 amp fault
9 VDC Patch Cords: (8) 3.5mm miniplug (tip hot)
to P205L 2.1mm x 5mm
“DC connector” (sleeve hot)
(1) 3.5mm miniplug (tip hot)
to 3.5mm miniplug (tip hot)
(1) 3.5mm miniplug (tip hot)
to 9 Volt battery clip (non-
perforated clip hot)
GENERAL
Weight SPB-8 unit: 11 lbs. (5 kg)
Travel Bag: 2.4 lbs. (1.1 kg)
Dimensions SPB-8 unit: 3.9” H x 26” W x 17.5” D (10 x
66 x 44.5 cm)
Travel Bag: 5.5” x 27.5” x 19” (14 x 70 x
48 cm)
Safety Agency Listings: CE and CSA / NRTL
SPB-8/8E AC Section