Furuno FMD-1712 - Manual (Page 28)

20
3.3 Selecting Radar Display,
Remote Display Function
This section shows you how to select the
radar connected to the FMD-1712 and
remote display function.
1. Press the [TX] key to set the equipment
in the stand-by mode.
2. Press and hold down and together
(about 10 seconds) to display the
maintenance menu.
NAV DATA (NMEA 0183)
GLL BWR BWC GLC GTD
RMA RMB RMC VTG MTW
DBT DBS DPT GGA
PROGRAM NO
03591690XX* SEL MENU
BY KEY
NORM DEMO
▲
▲
/
1
2
* XX = Program Version No.
MODEL 1712 1622
DISPLAY
Figure 3-9 Maintenance menu
3. Select 1 MODEL followed by 1712 or
1622 as appropriate.
4. Select 2 DISPLAY followed by NORM or
DEMO (shows internally generated
radar echoes on the FMD-1712) as
appropriate.
5. Press the [MENU] key to close the
menu.
3.4 Adjustments
Do the following in the order shown to
adjust the remote display.
1) Adjustment of picture
1. Press the [POWER] key on the display
unit.
2. Adjust the gain referring to paragraph
1.8 on page 4.
3. Adjust the STC referring to paragraph
1.9 on page 4.
2) Heading alignment
A small but conspicuous target dead ahead
visually should appear on the heading line
(zero degrees). In practice, you will
probably observe some small error on the
display. The following adjustment will
compensate for this error, up to ±30
°
.
1. Identify a suitable target (for example,
ship or buoy) at a range between 0.125
to 0.25 miles, preferably near the
heading line. To minimize error, keep
echoes in the outer half of the picture by
changing the range.
2. Press and hold down and together
(about 10 seconds) to display the
installation menu.
SEL MENU
BY
▲ / ▼ KEY
TOTAL ON TIME
00000 : 00
ADJUST PICTURE ORIENTATION
USING KEYS SO THAT
HEADING MARK BISECTS TARGET
LOCATED DEAD AHEAD.
Total hours remote
display has been
turned on
Instructions for item selected appear here
(shown: heading adjustment).
Menu
1 ADJ HDG
2 ADJ TMG
▲
▲
/
3 NM /KM
Figure 3-10 Installation menu
3. Select ADJ HDG. Your display should
now look something like the one shown
in Figure 3-11.
3. NM /KM
30 °
30 °
SEL MENU
BY
▲ / ▼ KEY
TOTAL ON TIME
00000 : 00
ADJUST PICTURE ORIENTATION
USING
KEYS SO THAT
HEADING MARK BISECTS TARGET
LOCATED DEAD AHEAD.
1. ADJ HDG
2. ADJ TMG
0.25 NM
.125
▲
▲
/
3. NM /KM
Figure 3-11 Display for
adjustment of heading