Fanimation The Benito Ceiling Fan FP8003 - Manual (Page 10)

10
How to Assemble the Blades and Light Kit (continued)
MOTOR ASSEMBLY
2-PIN CONNECTOR
SOCKET PLATE
ASSEMBLY
SOCKET PLATE 2-PIN
CONNECTOR
Figure 4
HOUSING LIGHT
KIT ASSEMBLY
SOCKET PLATE
SCREWS (3)
Figure 5
Figure 6A
4. Connect the 2-pin connector from the socket
plate assembly to 2-pin connector from motor
assembly (Figure 4).
FROSTED
GLASS
OPAL LOWER STELL
CAP ASSEMBLY
Figure 7A Figure 7B
5. Remove one of the three screws in the plate
assembly. Slightly loosen the remaining two
screws. Assemble the socket plate to the
adapter plate assembly using the two key slots.
Replace the third screw and securely tighten all
three screws (Figure 5).
Figure 6B
100-WATT
MINICAN LIHGT BULB (1)
LIGHT SOCKET
LIGHT SOCKET
6. Insert light bulbs into sockets (Figure 6 A).
6A. Don’t install the light bulbs if you want to install
the lower steel cap in Step 7A (Figure 6 B).
7.
Assemble the opal frosted glass to the adapter
plate assembly by twisting in a clockwise direction.
Do not over-tighten (Figure 7 A)
7A. Assemble the lower steel cap to the adapter plate
assembly by twisting in a clockwise direction.
(Figure 7 B).
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.