Fanimation The Benito Ceiling Fan FP8003 - Manual (Page 7)

7
How to Wire Your Ceiling Fan
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 1).
WARNING
!
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
NOTE: The hand-held remote included with this fan
has 16 different code combinations. To prevent
possible interference from or to other remote units,
simply change the combination code in your
transmitter and receiver.
1. To set the transmitter code, remove battery cover
by pressing firmly below arrow and sliding cover
off. Slide code switches to your choice of up or
down position. Factory setting is all up. Do not use
this position. With a small screwdriver or ball point
pen slide firmly up or down. Replace battery cover
on the transmitter (Figure 2).
2. To set the receiver unit code, slide code switches
to the same positions as set on your transmitter
(Figure 3).
3. Slide the receiver unit into the open end of the
hanger bracket (Figure 4).
4. Connect green wires from hanger bracket and
hanger ball to bare (ground) wire using wire
connector supplied. Connect black wire from
receiver unit marked “AC IN L” to black supply wire
using wire connector supplied. Connect white wire
from receiver unit marked “AC IN N” to white supply
wire using wire connector supplied. Connect white
wire from receiver unit marked “TO MOTOR N” to
white wire from fan using wire connector supplied
with receiver. Connect black wire from receiver unit
marked “TO MOTOR L” to black wire from fan
using wire connector supplied. Lastly, connect blue
wire from receiver to the blue fan light wire using
wire connector supplied. Position all connected
wires and receiver antenna to allow installation of
ceiling canopy (Figure 5).
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
HANGER BRACKET
RECEIVER UNIT
Figure 4
GREEN WIRE
(Ground)
GREEN WIRE
(Ground from
hanger ball)
GREEN WIRE (Ground
from hanger bracket)
WHITE
WHITE to Motor BLACK to Motor
BLUE to Light
WHITE
BLACK
BLACK
BLUE
BLACK WHITE
BLACK - ANT
LISTED
OUTLET BOX
Figure 5
REMOTE
TRANSMITTER
UNIT DETAIL
TRANSMITTER CODES
RECEIVER
UNIT
DETAIL