FELLOWES Helios 30TM User Manual
Page 6
6
Switch the power on (located at the rear side).
The ‘Power-On’ button will be red. To activate the
machine, press the ‘Power-On’ button on the control
panel. The machine will warm-up, the red LED will
flash. The machine will ‘beep’ (3x) and the LED
turns green when the machine is ready to bind.
Prepare the documents by loading the sheets into
the thermal covers. For best results, do not to place
too many or too few sheets into the cover. Use the
binding thickness scale as a guide. The guide is cali-
brated in 6mm widths. Helios 30 will accept single or
multiple documents up to a combined total thickness
of 1.25” (approximately 300 sheets / 20lb).
The selected binding cycle is shown with blue LED.
Use the timer selection buttons to navigate up or
down the scale, if required. The scale has 10 settings.
Eg: 0.25” document thickness = setting 1 (up to
60 sheets), 1.25” document = setting 10 (up to 300
sheets).
Pull open the document clamp (Heat-Shield fea-
ture), insert the documents into the binding channel.
Ensure the binding covers spine touches the heating
element.
Start the binding cycle by pressing the ‘Select / OK’
button. The blue LED will start flashing and counting
down, in sequence. When the cycle is complete, the
machine will beep (3x). The blue LED will switch off.
The machine has an integral cooling tray. It can be
extended from the back of the machine and can also
be pulled upwards to accept larger documents.
When the binding cycle is complete, immediately
remove the documents and place in the cooling tray
or on a flat surface to allow the document to cool.
The document can be removed from the machine
mid-cycle if required, take care – the glue may be
hot and melted.
5.
6.
7.
8.
9.
10.
11.
12.
HOW TO BIND
Let our experts help you with a solution.
Customer Service...
www.fellowes.com
Always call Fellowes before contacting your place of purchase,
see the rear cover for contact details.
NEED HELP?
Ensure the machine is on a stable surface. Check
there is enough clear space around the machine to
operate safely.
Insert the power lead into the power socket (located
at the rear of the machine).
Plug the machine into an easily accessible main
socket. Switch the main supply on.
Open and lift the lid by releasing the safety catches
on the front of the lid.
1.
2.
3.
4.
BEFORE BINDING