Furuno FM-8500 - Manual (Page 16)

12
DSC Antenna
The antenna should be well separated from nearby antennas, masts,
and other interfering objects.
The mounting procedure is the same as that for the VHF antenna,
however consult appropriate outline drawing for details.
Handset Hanger
The handset hanger can be mounted at the front or rear of the trans-
ceiver unit. To mount the hanger at the rear of the unit, a connector
and connector assembly are required (option). The mounting loca-
tion should provide easy access to front panel controls while operat-
ing the handset. Also, the length of the standard handset cable is 50
cm, so locate the handset hanger within 50 cm of the unit. (Longer
cables are available optionally.)
Power Supply (option)
For Convention vessels, both AC and DC power must be fed to the
FM-8500, via an AC/DC power supply. When AC input fails, DC
power is supplied. FURUNO can supply an AC/DC power supply
unit, the PR-300.
Mounting considerations
When selecting a mounting location, keep in mind the following
points.
• Select a location which provides adequate ventilation.
• The location must be clean and dry.
• The mounting location must be able to support the weight of the
unit (14.5 kg) under the continued conditions of vibration normally
encountered aboard the vessel. If necessary, reinforce the mount-
ing location.
• The PR-300 will affect a magnetic compass if it is placed to near
the compass. Observe the compass safe distance to prevent devia-
tion of a magnetic compass;
Standard compass: 0.9 m
Steering compass: 0.7 m
Mounting
Refer to outline drawing.