Name of parts, En-3 – FUJITSU AOU18RL User Manual

Page 6

Advertising
background image

En-3

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button

●

When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.

●

The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.

●

When the forced cooling operation starts
by any chance, press the START/STOP but-

ton to stop the operation.

3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)

●

If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting

(See Page 14 Auto Restart).

7 SUPER QUIET Indicator Lamp (green)
8 COIL DRY Indicator Lamp (orange)

9 Intake Grille (Fig. 4)
0 Front Panel
A Air Filter
B Air Flow Direction Louver
C Right-Left Louver

(behind Air Flow Direction Louver)

D Drain Hose
E Air Cleaning Filter

Fig. 5 Outdoor Unit

F Pipe Unit
G Drain port (bottom)
H Intake Port
I Outlet Port

Fig. 6 Remote Control Unit

J SLEEP button
K MASTER CONTROL button
L SET TEMP. button ( / )
M COIL DRY button
N Signal Transmitter
O TIMER MODE button
P TIMER SET ( / ) button
Q FAN CONTROL button
R START/STOP button
S SET button
T SWING button
U RESET button
V TEST RUN button

● This button is used when installing the

conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.

● If this button is pressed during normal op-

eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.

● To stop the test operation mode, press the

START/STOP button to stop the air condi-
tioner.

W CLOCK ADJUST button
X Remote Control Unit Display (Fig. 7)
Y Transmit Indicator
Z Clock Display
[ Operating Mode Display
\ Timer Mode Display
] Fan Speed Display
` Temperature SET Display
a COIL DRY Display
b SLEEP Display
c SWING Display

NAME OF PARTS

● Refer to the folded out page on the cover.

05L256_9315255013-01_En

2005.12.9, 11:49 AM

3

Advertising
This manual is related to the following products: