Friedrich MW30C3G - Manual (Page 7)

En-6
To Select Mode Operation
1
Press the START/STOP button (Fig.6 P).
The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5) will light.
The air conditioner will start operating.
2
Press the MASTER CONTROL button (Fig.6 J) to select
the desired mode.
Each time the button is pressed, the mode will change in the following order.
▲ ▲ ▲ ▲
AUTO COOL DRY FAN
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. button (Fig. 6 K).
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
● Thermostat setting range:
AUTO ....................................64-88 °F
Cooling/Dry ...........................64-88 °F
The thermostat cannot be used to set room temperature during the FAN mode (the tem-
perature will not appear on the Remote Controller’s Display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ some-
what from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 O).
Each time the button is pressed, the fan speed changes in the following order:
▲ ▲ ▲ ▲ ▲
AUTO HIGH MED LOW QUIET
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling : As the room temperature approaches that of the thermostat setting, the fan
speed becomes slower.
Fan : The fan runs at the MED fan speed.
SUPER QUIET Operation
When set to Quiet:
SUPER QUIET Indicator Lamp (orange) (Fig. 3 7) will light.
SUPER QUIET operation begins. The indoor unit’s airfl ow will be reduced for quieter
operation.
● SUPER QUIET operation cannot be used during Dry mode. (The same is true when
dry mode is selected during AUTO mode operation.)
● During Super Quiet operation, Cooling performance will be reduced somewhat. If the
room does not cool down when using SUPER QUIET Operation, please adjust the air
conditioner’s Fan Speed.
OPERATION
Example: When set to COOL.
Example: When set to 80 °F.
Example: When set to AUTO.
9315345394_OM.indb 6 9315345394_OM.indb 6 9/30/2010 2:44:22 PM 9/30/2010 2:44:22 PM