Farenheit Technologies DVD-19 - Manual (Page 29)

-29-
REFERENCE
Check the following guide for the possible cause of a problem before contacting service.
No Power
The power is on, but the
player does not work.
No picture.
No sound.
The playback picture is poor.
The player does
not start playback.
The Remote control does
not work properly
The POWER button and
the other buttons are not
operated.
Plug the power cord into the battery outlet securely.
Insert a disc. (Check that the DVD or audio CD
indicator in the display is lit.)
Select the appropriate video input mode on the TV so
the picture from the player appears on the TV screen.
Connect the video cable into the jacks.
Turn on the TV.
Select the correct input mode of the audio receiver so
you can listen to the sound from the player.
Connect the audio cable into the jacks securely.
Turn on the equipment connected with the audio cable.
Set the Digital Audio Output to the correct position, then
turn on the player again by pressing the POWER button.
Clean the disc.
Insert a disc.(Check that the DVD, or audio CD indicator
in the display is lit.)
Insert a playable disc.(Check the disc type, color system
and Regional code.)
Place the disc with the playback side down.
Place the disc on the disc tray correctly inside the guide.
Clean the disc.
Press the SETUP button to turn off the menu screen.
Cancel the Parental function or change the parental
level.
Point the remote control at the remote sensor of the
player.
Operate the remote control within about 5m.
Remove the obstacle.
Replace the batteries with new ones.
In this case unplug the power cord of the player,
and then plug in the power cord again.
The power cord is disconnected.
No disc is inserted.
The TV is not set to receive DVD signal
output.
The video cable is not connected
securely.
The connected TV power is turned off.
The equipment connected with the
audio cable is not set to receive DVD
signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The Digital Audio Output is set to the
wrong position.
The disc is dirty.
No disc is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
A menu is on the TV screen.
The Parental level is set.
The remote control is not pointed at the remote
sensor of the player.
The remote control is too far from theplayer.
There is an obstacle in the path of the
remote control and the player.
The batteries in the remote control are
exhausted.
The buttons or screen holding
error may occur by some discs.
Symptom Cause Correction
Troubleshooting Guide