FujiFilm 2800 Zoom - Manual (Page 36)

70
6
71
● ! Do not disconnect the USB cable when the camera
is communicating with the PC. See P.72 for
information on the disconnection procedure.
i The indicator lamp alternately blinks green and
orange while the camera is communicating
with your PC.
i The lens is fixed at the wide-angle zoom
setting.
i “PC CAM” appears on the screen.
i The camera does not automatically switch off
when a USB connection is being used.
i FinePixViewer automatically starts up and the
Picture Hello window opens (Windows only).
i You can use software
such as VideoImpression
to view live images.
Camera Operation PC Operation
✽ Screen for Windows 98 SE
✽ Screen for Macintosh
If the above operations do not occur, you do not
have the required software programs or drivers
installed on your PC. Refer to the Software
Quick Start Guide booklet and complete the
required PC setup procedures. Then reconnect
the camera to your PC.
CONNECTING AT PC-CAMERA MODE
(USB)
Socket
PC
Camera
(Special USB)
socket (Special USB)
socket
DC IN 5V Socket
1Remove the lens cap.
2Press the “POWER” button to switch the
camera on.
3Set the “USB MODE” setting in the “SET–UP”
menu to “PC CAM” ( ➡P.62, 63).
4Press the “POWER” button to switch the
camera off.
2
1Switch your PC on.
2Use the special USB cable to connect the camera to
your PC.
3Switch the camera on.
Always use the prescribed procedure when
disconnecting or switching off the camera (
➡P.72).
●
! You should use the AC power adapter when the camera
is connected to your PC (
➡P.19). Loss of power during
data transmission can prevent successful data
downloading.
●
! If you are using Windows XP, you must also refer to the
Software Quick Start Guide booklet.
● !
Take care to connect the plugs on the special USB cable
into the correct sockets, and ensure that the plugs are
inserted firmly.
1 0 1
0 3
0 2 0 4
On Windows PCs (excluding Windows XP), if the
“Add New Hardware” wizard appears, close the
wizard and switch off the camera. You must install
the software before connecting the camera to your
PC. (
➡Software Quick Start Guide booklet)