FARGO electronic STYLUS NX625 - Manual (Page 26)

26 Network Setup
Network Setup
This section provides detailed instructions for setting up your product on a
wireless or wired network.
Make sure you follow the instructions on the Start Here sheet to set up your
product, choose your connection, and install the software. The on-screen
instructions during the installation process help you set up your network
connection. Follow the instructions in this chapter only if you need additional
help:
■ For wireless network setup, see below.
■ For wired network (Ethernet ® ) setup, see page 40.
Wireless Network Setup
The steps in this section provide detailed instructions for setting up your product
on a wireless network.
You must install the software on every computer from which you want to print.
For the first installation, we recommend using a USB cable (not included) to
simplify wireless setup. After the printer is connected to the network, you will be
prompted to remove the cable.
If you’re using Mac OS X 10.6 or don’t have a USB cable, you’ll need to use the
buttons on the printer to select wireless settings instead.
Note:
If you have trouble setting up your product, see “Network Problems” on page 46.
■ If this is the first time that you’re installing the product, see “Installing for the
First Time” on page 27.
■ If your product is already on your wireless network and you need to set up
additional computers to print to the product, see “Setting Up Additional
Computers” on page 37.