Fisher 77770 - Manual (Page 12)

12
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Lens
Wide
Notch
Wide Tab
Lens Guard
Assembly
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tab
Tab
Slot
Slot
14
15
Steering Wheel
• Fit the steering wheel cap into the center of the
steering wheel.
• Insert two #8 x 1" screws, as shown.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Steering
Wheel Cap
• Turn the vehicle upright.
• Position the steering wheel so that the spokes form a
“Y” as shown. The tab on the steering wheel stem
should face up.
• Fit the steering wheel onto the steering column.
• Fit a cap nut onto the end of the steering column.
• Tap the cap nut with a hammer to secure it on the
steering column.
Hint: You may want the help of another person to
support the steering column while you tap the cap nut
with the hammer.
Steering Wheel
Cap
Nut
Steering
Column
“UP”
Tab
12
13
.354"
.354 Cap Nut