Fisher-Price H5985 - Manual (Page 4)

4
• Locate the hole in each side rail.
• With the vibrations unit facing forward, fit the front tube to the side
rails, as shown. Hold the front tube in place and proceed to step 6.
• Insert a M5 x 30 mm screw through the outside of each side rail
and into the ends of the front tube.
IMPORTANT! Please follow the next assembly (step 7) carefully to
completely secure the front tube to the side rails.
Side Rail Hole
Side Rail Hole
Vibrations Unit
Front Tube
5
6
Assembly
Retainer
with Lock Nut
• Fit a retainer with lock nut onto the end of the screw and to the
inside of a side rail. Tighten the screw.
Hint: A lock nut has been factory assembled to the retainer.
During shipment, the lock nut may have fallen out of the retainer.
If it has, please fit it into the hexagonal hole in the retainer so that
the rounded side of the lock nut faces out.
• Repeat this procedure to fasten the screw in the other end of the
front tube and side rail, using the remaining retainer with lock nut.
• Fit the kickstand onto the assembly, as shown.
• Insert two screws into the holes on each side rail and tighten.
7
Kickstand
8