Fisher 1000-(10003) - Manual (Page 9)

Lit. No. 94430/94431 7 April 1, 2005
MOUNTING THE SPREADER
Fixed Mount Spreader
WARN ING CAUT ION
NOTE: The spreader shall be installed according to
instructions supplied. Your local outlet is trained to
provide this service and service your spreader with
factory original parts.
1. Install the left and right top brackets to the truck
bed rail with one 1/2" cap screw, one 1/2" flat
washer and one 1/2" locknut. Attach the other hole
in the top bracket to the bed rail with one 1/2" cap
screw and one 1/2" locknut.
2. Place the spreader on the bumper and line up the
holes in the bottom feet with the holes in the
bumper.
3. Attach the spreader to the top brackets using two
3/8" cap screws and two 3/8" locknuts per side.
4. Attach the spreader to the bumper of the truck
using one 3/8" cap screw, one 3/8" flat washer and
one 3/8" locknut per side.
5. Plug the spreader harness into the vehicle harness.
CAUTION
During removal or mounting, securely grip
spreader to avoid dropping.