Franklin RK-8201 - Manual (Page 3)

Getting Started
The first time you use this device, you should perform a
system reset. Warning! A system reset erases any user-
entered information.
1. Turn the device over and carefully pull the battery
insulation sheet to remove it.
2. Press to turn the device off.
3. Use a paper clip to gently press the reset button on the
back of the device.
The Reset button is accessed via the hole to the left of
the battery door on the back of the unit.
4. Press Y to reset the device.
System Setup
You can select the date and time formats, activate or
deactivate a keytone, set a daily alarm and a four-digit
passcode and select a language for the messages and
prompts.
1. Press SHFT and then press SPACE (
SYSTEM ) to see
the Setup Menu.
2. Use VIEW/NEXT to find the setting you want.
3. Press Y to change a setting or N to leave the setting
unchanged.
After entering a time for the alarm, entering a
passcode or selecting a language, you must press
SAVE.
Warning! Please write down your passcode. If you enter
the wrong passcode you will not be able to use your
organizer unless you perform a system reset, which will
result in a loss of all your data.
Setting the Date and Time
1. Press .
2. Press EDIT.
3. Enter the time and press A or P for a.m. or p.m. if
necessary.
4. Press VIEW/NEXT to set the date.
5. Enter the date.
6. Press SAVE to save your settings.
The time is displayed.
7. Press VIEW/NEXT to see the date.
Cautions
• Do not carry the device in the back pocket of your
slacks or trousers.
• Do not drop the device, apply excessive force to it or
subject it to extreme temperatures.
• Clean only with a soft, dry cloth.
• Since this product is not waterproof, do not use it or
store it where fluids can splash onto it. Raindrops,
water spray, juice, coffee, steam, perspiration, etc. will
also cause the device to malfunction.
• Always keep written records of your data.
Entering a Record
1. Press or .
2. Press NEW.
3. Enter data in the first field.
4. Use VIEW/NEXT to go to other fields and enter data in
the fields you want.
5. Press SAVE to save the record.
Viewing a Record
1. Press or .
In the Memo, press to scroll through your
memos.
2. Type the first few letters of the record you want.
In the Contact File, you can also press to scroll
through the letter tabs until you reach the one you
want.
3. Press VIEW/NEXT to start the search.
4. Use VIEW/NEXT to cycle through the fields.
Only fields with data in them are displayed.
ABC ABC
ABC ABC