Freedom9 KVM-08P - Manual (Page 14)

Chapter 3: Console Operation
11
Selecting Computer Using Push Button
Reset Button:
Press Port Select and Bank Select of bank 1 (master) simultaneously to reset KVM switch. This
reset action will not only return KVM switch back to initial state but it will also re-check any slave
banks which are connected to the master KVM switch.
If you add a new KVM SWITCH as a slave bank, please use reset button of master KVM switch
to assign a new ID to the slave. You can view the new slave bank by using the OSD menu after
the reset.
Example:
To access a computer attached to Port 3 of the first Bank. First, you can push Bank Select
once, and the Bank No will display current Active (1) Bank. Then you can push Port Select three
times and the Port No will display Port Status (3) Port.
Bank No. Bank Select Port No. Port Select
Reset
Port Status Current Active Bank Display
Bank Select Port Select