FUJITSU MB95F430 - Manual (Page 18)

Operational Amplifier Version 1.0
Chapter 9 Sample Code
MCU-AN-500080-E-10 - Page 18
#pragma intvect DefaultIRQHandler 6 // IRQ6: 8/16-bit timer ch0 (upper)
#pragma intvect DefaultIRQHandler 7 // IRQ7: Output Compare ch0
#pragma intvect DefaultIRQHandler 8 // IRQ8: Output Compare ch1
#pragma intvect DefaultIRQHandler 9 // IRQ9: none
#pragma intvect DefaultIRQHandler 10 // IRQ10: Voltage Compare ch0
#pragma intvect DefaultIRQHandler 11 // IRQ11: Voltage Compare ch1
#pragma intvect DefaultIRQHandler 12 // IRQ12: Voltage Compare ch2
#pragma intvect DefaultIRQHandler 13 // IRQ13: Voltage Compare ch3
#pragma intvect DefaultIRQHandler 14 // IRQ14: 16-bit free run timer
#pragma intvect DefaultIRQHandler 15 // IRQ15: 16-bit PPG0
#pragma intvect DefaultIRQHandler 16 // IRQ16: I2C ch0
#pragma intvect DefaultIRQHandler 17 // IRQ17: none
#pragma intvect DefaultIRQHandler 18 // IRQ18: 10-bit A/D-converter
#pragma intvect DefaultIRQHandler 19 // IRQ19: Timebase timer
#pragma intvect DefaultIRQHandler 20 // IRQ20: Watch timer
#pragma intvect DefaultIRQHandler 21 // IRQ21: none
#pragma intvect DefaultIRQHandler 22 // IRQ22: none
#pragma intvect DefaultIRQHandler 23 // IRQ23: Flash Memory
/*---------------------------------------------------------------------------
DefaultIRQHandler()
This function is a placeholder for all vector definitions.
Either use your own placeholder or add necessary code here
(the real used resource interrupt handlers should be defined in the main.c).
-----------------------------------------------------------------------------*/
__interrupt void DefaultIRQHandler(void)
{
__DI();
// disable interrupts
while(1)
__wait_nop();
// halt system
}