Fishman SBT-C - Manual (Page 4)

4
Preparation
The model SBT-C may be mounted onto a classical guitar, a steel string guitar, a
dulcimer and similar stringed instruments. The installation may be performed
either on the outside of the instrument or inside the soundhole where the
transducer will be out of harm’s way. In instruments with small soundholes
(dulcimers, for example), internal installation may not be practical.
As a general rule, the transducer
should be mounted over a freely
vibrating location and
not over a “dead” structural brace.
The exact location for best results
should be determined
by experimentation.
1. Determine the approximate loca-
tion of the transducer by measuring
about 1.5” (3.8cm)
below the bridge and 1.5” (3.8cm)
JACK
HOLDER
JACK
STRAIN
RELIEF
CLIP