Fishman SBT-C - Manual (Page 8)

8
Install the pickup
1. Widen the endpin hole to 15/32” (11.9mm) to accommodate the endpin jack.
For additional information, please refer to the Switchjack Installation Guide
located at fi shman.com.
2. Solder the pickup “hot” wire to the Tip terminal, which is the shortest of
the three tabs. Solder the pickup shield to the Ground tab on the jack. Gently
tighten the strain relief.
Shield
Tip
(Short Terminal)
r a ti u G
Switch
(Long Terminal) Ring
(Medium Terminal)