Freecom Technologies RCS-S5000B - Manual (Page 7)

THE CONTROL PANEL
1. POWER ON/OFF "I/O"
Easy push-button control switch to turn the unit ON and OFF.
2. MODE
There are five different fan speed settings:
• AUTO—Automatic fan speed with cooling setting by room temperature.
• HI—High fan speed with cooling setting
• MED—Medium fan speed with cooling setting
• LO—Low fan speed with cooling setting.
• FAN—Fan only (no cooling)
3. MODE LEDs
Individual LED lights to show mode in operation.
4. COMPRESSOR LED
Lights to show compressor is operating (cooling modes).
5. THERMO CONTROL
The Thermo Control automatically defaults to a temperature of approximately 77ÞF when
the unit is initially plugged in and started. Press right button to lower cooling setting;
press left button to raise cooling setting. Each press of either button adjusts the tempera-
ture control by approximately 1ÞF. The temperature setting range is 68ÞF to 86ÞF.
6. DIGITAL DISPLAY WINDOW
Digital display shows room temperature and "TIMER" setting, if applicable.
7. TIMER SET
Adjustable 24 hour timer can be programmed to turn off or on after pre-selected time.
8. TIMER LED
Individual LED lights to show if the timer is selected for "ON" or "OFF."
9. AUTO SWING
Press to automatically begin (or stop) louvers moving up and down.
10. DRAIN WATER LED
Lights to indicate water must be drained.
11. REMOTE CONTROL OPERATION SENSOR
1
2
5
4 3
6
7
7
8
9
10
11