Freecom Technologies RCS-S5000B - Manual (Page 8)

BEFORE USING
IMPORTANT: Remove unit from packaging and discard clear, plastic wrapping. Place
both units in upright position for a minimum of two hours before operating for the first
time.
CAUTION: Never use line/tube set to move, carry, or lift units. DO NOT place units
near open flame or heat source.
8
INSTALLATION
Indoor Unit
1. Place indoor unit on a solid, level surface.
Operating this unit on uneven or
soft surfaces may cause vibration,
noise, and possible water leakage.
2. Place indoor unit at least 30" from any
draperies or other obstructions.
Carefully push the unit on its castor wheels
to desired location.
3. Determine a location for outdoor unit.
If surface mounting, be sure outdoor unit
can be placed at least 12" from any wall. Be
sure the location is within reach of the tube
set. The outdoor unit should be on a flat,
level, solid surface or wall-mounted using
the supplied mounting brackets.
NOTE: Height location of outdoor unit must not
exceed 6 feet (2 meters) above indoor unit.
CAUTION: Do not operate unit without
air filter properly in place.
4. Check that air filter is clean and properly
installed.