Faber Remote Blower - Manual (Page 13)

13 EN
Electrical connection
ELECTRICAL SHOCK HAZARD
• Disconnect power before making electrical connctions.
• Connect ground wire to green ground screw in terminal box.
! WARNING
green
ground
screw hood wiring
purple wiring red wiring
hood wiring
black wiring
white wiring
power
supply
conduit light wiring
exterior
blower
wiring
twist-on
connectors
blue wiring
brown wiring
• Connect the red wire of the Light cable with the red lead in the hood
using a twist-on connector; connect the purple wire of the Light cable
with the purple lead in the hood using a twist-on connector.
• Connect the blue blower wire with the blue lead in the hood using a twist-
on connector; connect the brown blower wire with the brown lead in the
hood using a twist-on connector.
• Connect the ligth unit to the ground using one of the following two alter-
native ways:
a- Connect the domestic green ground wire under the unused green ground
screw belonging to the light unit wiring box using a listed conduit
connector.
b- Connect one end of the green ground wire (max lenght 10 yards using
14 awg wire) under the unused green ground screw belonging to the
light unit wiring box and the other end under the unused green ground
screw belonging to the range hood wiring box.
• Connect the green ground wire (from exterior blower and from power
supply cable) under the unused green ground screw.
• Tighten strain relief screws.
• Connect the white wire of the power supply conduit with the white lead
in the hood using a twist-on connector; connect the black wire of the
power supply conduit with the black lead in the hood using a twist-on
connector.
• Place the suction panel so that the connection flat wiring for the hood
controls passes through the specific opening in the hood body.
• Fix the suction panel to the hood body fastening the screws removed
earlier.
• Open the suction cover using the lever provided.
• Connect the flat connection wiring coming from the hood controls with
the connector piece placed close to the terminal box. Only in case of the
bottom air outlet configuration remove the protection cover from the
connector piece on the opposite side of the terminal box.
• Fix the terminal box cover again and fasten the 2 screws removed earlier.
• Replace the metal grease filters in their housings.
• Close the suction panel.