Furuno FMD-811 - Manual (Page 17)

7
1.11 Selecting the Presentation
Mode
FMD-811 provides four presentation modes:
head-up, course-up (course-up or waypoint-
up; selectable on menu), north-up and true
motion. Press the [DISP MODE] and [HM
OFF] keys together to select a presentation
mode. Each time the keys are pressed, if
heading signal is input to the radar, the pre-
sentation mode changes in the sequence of
HU, CU (or WU), NU, TM. If there is no
heading signal input to the radar, the pre-
sentation mode is always HU.
Selecting WPT-UP mode
You may select WPT-UP instead of CU on
the menu.
CU (couse-up)
An azimuth stabilized display in which the
line connecting the center with the top of
the displau indicates own ship's intended
course.
WPT-UP (waypoint-up)
An azimuth stabilized display in which the
line connecting the center with the top of
the display indicates the bearing to the “TO”
waypoint, which is selected on the
radionavigational equipment connected to
the radar. When navigating a route and own
ship enters the arrival zone of a waypoint,
the radar displays the bearing to the next
“TO” waypoint.
Procedure
1. Press the [MENU] key to open the menu.
HU
(head-up)
TM
(true motion)
NU
(north-up)
WPT-UP
(waypoint-up)
CU
(course-up)
2. Press the cursor pad to select 2. P/L, IR,
NR & Radar Mode.
3. Press the cursor pad to select Radar mode.
4. Select option for CU or WPT-UP.
5. Press the [ENT] key followed by the
[MENU] key.
1.12 Menu Operation
The menu, consisting of 6 sub menus, mostly
contains less-often used functions which
once preset do not require regular adjust-
ment. To open or close the menu, press the
[MENU] key. You can select items on the
menu with the cursor pad
Basic menu operation
1) Press the [MENU] key to open the menu.
The main menu appears.
Figure 1-9 Main menu
2) Press the cursor pad to select menu and
press the [ENT] key.
3) Press the cursor pad to select menu item.
4) Press the cursor pad to select option.
5) Press the [ENT] key to register selection.
6) Press the [MENU] key to close the menu.
Menu description
See the table on the next page.
MAIN MENU
Select item by keys
and press ENT key.
1. Backlight/Brilliance
2. P/L, IR, NR & Radar Mode
3. Nav Data
4. Mode & Function
5. Tuning AUTO MANUAL
6. Self Check
7. Installation Setup 1
. . . . . . . . . . . . . . . . .
Set pulselength and interference/noise
rejectors and CU/WPT-UP in Radar mode.
<Press MENU key to escape.>