Furuno GP-3300 - Manual (Page 56)

4-9
3. Place the cursor on latitude and longitude position desired for
destination waypoint. Note that if you place cursor near a mark
or a waypoint displayed, cursor position (destination waypoint)
is pulled into the mark displayed.
4. Press the [ENT] key
Setting destination waypoint by waypoint
number
1. Press the [FR/TO] key to display the DESTINATION SETTING
menu.
DESTINATION SETTING
DEST = SET CANCEL
MODE = CURSOR WAYPOINT ROUTE R/B
WPT NO. = 0 0 +
− −
+
− −
+
− −
+
− −
+
− −
+
− −
+
− −
+
+
− −
+
− −
+
− −
+
− −
+
− −
+
− −
+
− −
+
−
ENTER WAYPOINT NO.
Figure 4-10 DESTINATION SETTING menu
2. Select WAYPOINT from the MODE field.
3. Select WPT NO.
4. Enter waypoint number(s) in two digits. If the waypoint number
is 07, for example, press [0] and [7].
5. Press the [ENT] key.
Note: The message “DATA ERROR” appears on the display when
the waypoint number entered is not registered.
Setting destination waypoint by range and
bearing
1. Press the [ENT] key to display the DESTINATION SETTING
menu.
2. Select R/B from the MODE field.
3. Select RANGE.
4. Enter range.
5. Select BEARING.
6. Enter bearing.
7. Press the [ENT] key twice.