Furuno GP-3300 - Manual (Page 65)

5-6
that takes you through a seawall or over land! It is far better to leave
a reasonable arrival alarm range of say 0.1 nautical miles, and when
you get as close as safely possible to the desired waypoint which is
now blocked then manually override the route planning mode and go
to manual waypoint sequencing.
Note: In some instances waypoints on a route may not be connected.
If this is the case;
1) Check setting of ROUTE LINE on menu 96.
2) Try reformatting the display.
3) An intermediate waypoint may be selected by the arrival alarm
range. If this is the case, make the alarm range smaller. Note that the
arrival alarm range remains in effect in route navigation even when
the arrival alarm itself is turned off.
5.3 Temporarily Deselecting a Route Waypoint
A route waypoint may be deselected temporarily by entering a “-”
(minus) to the left of the route waypoint on the ROUTE list. Using
Figure 5-7 as an example, you would want to temporarily deselect
route waypoints 04, 05 and 06, since your ship is to traverse the route
in the order of route waypoints 03, 02 and 01.
The temporarily deselected route waypoint may be restored at any
time by entering a plus sign next to the deselected route waypoint
number.
PORT
PORT
Waypoint 01 Waypoint 02
Waypoint 03
Waypoint 04
Waypoint 05
Waypoint 06
Figure 5-7 Example of when to deselect waypoints
1. Press the [MENU] key.
2. Press the [2] key to display the ROUTE list.
3. Press the [ ] key to select route.
4. Place the cursor on the waypoint you want to deselect.
5. Press [
←
] to place the cursor on a digit in the WAYPOINT col-
umn.