Installing the projector – Meridian Audio FDP-DILA3 User Manual
Page 17
1
7
QU
IC
K A
LIG
N.
PC
VID
EO
VO
LU
ME
PR
ES
ET
HID
E
ME
NU
EX
IT
FR
EE
ZE
OPE
RA
TE
V-KEYSTON
E
H-KEYS
TONE
SC
RE
EN
DIG
IT
AL
ZO
OM
FOCUS
W
S
EN
TER
Screen
Projector
Projector
Remote Control
Unit
Remote Control Sensor
(rear)
20˚
20˚
30˚
A
B
30˚
QU
IC
K AL
IGN.
PC
VID
EO
VO
LU
ME
PRES
ET
HIDE
MENU
EXIT
FR
EEZE
OP
ER
ATE
V-KE
YST
ONE
H-K
EYS
TON
E
SC
RE
EN
DIG
IT
AL
ZO
O
M
FOCUS
W
S
EN
TE
R
30˚
20˚
20˚
30˚
Aim the remote control unit towards the remote sen-
sor on the front or rear of the projector. The operable
distance of the remote control unit is about 7m for di-
rect reception. If the remote control fails to work prop-
erly, move closer to the projector.
Remote Control
Unit
QUICK
ALIGN.
PC
VIDEO
DIGITAL
ZOOM
HIDE
VOLUME
PRESET
ESCAPE
ENTER
MENU
FREEZE
OPERATE
REMOTE
RS-232C OUT
CONTROL
Remote Cable
(sold separately)
Remote control
(sold separately)
Projector
Again, when a remote cable is connected to the REMOTE terminal of the
projector, the sensor would not work. Check to see if the cable is connected.
When a remote cable is connected to the remote control terminal, the
transmitter would not work.
Effective Range and Distance of the Remote Control Unit
When the remote control unit fails to work properly
• When the batteries in the remote control unit are exhausted, improper functioning would occur. Please replace with new
batteries.
• When either the remote control unit or projector alone is connected to the remote cable, the connected side will not be able
to work. Please check the cable connection.
The operable distance of the remote control unit is about 7m for direct reception. The remote control unit can be used by having the
transmission signals reflected by the screen. In this case, please set the total distance (distance between projector and screen,
A and distance between remote control, B) of “A + B” within 7m. The operable angles of the remote control unit are 30˚ right
and left, and 20˚ up and down.
Ⅵ Using as a wireless remote control unit
As the effect of signals reflected from the remote control unit differ with the type of screen used, effective range and distance
may decrease.
Ⅵ Using as a wired Remote Control
By connecting a separately sold remote control (RM-M3010) and cable (about 3m: QAM0081-001/ 15m: QAM0247-001) to the
REMOTE terminal, the remote control can be used as a wired control unit. When connected to the cable, the remote control’s
transmitter and the projector’s sensor would not function. Please keep within the range of the remote cable length. Warranty is
not extended to the case where an extension cord is used.
❈ The ESCAPE button on the separately sold remote control (RM-M3010) is equivalent to the EXIT button on the supplied
remote control unit. There is no equivalent to the H, V-KEYSTONE and FOCUS buttons found on the supplied remote control.
Installing the Projector