Meridian Audio FDP-DILA3 - Manual (Page 43)

4 3
Lamp unit
3.
Remove the lamp unit.
Replacing the Lamp
4.
Insert the new lamp unit fully in.
5.
Close the handle, and tighten the screw.
Tighten the two screws with a ª screwdriver.
6.
Attach the light-source lamp cover and tighten
the screw.
Tighten the two screws with a ª screwdriver.
Note
When closing the lamp cover, please insert the left
side (with the two claws) in first and then ensure that
the protruding part found on the reverse side of the
cover fits snugly into the hole of the main unit. As this
protrusion acts as a switch, misfitting leads to power
not being able to flow in.
Caution
Neither touch the glass surface of the lamp directly
with your hand nor stain it. If you touch it with a bare
hand, oil and other substances on your hand may ad-
here to the lamp, possibly preventing it from perform-
ing as specified and therefore leading to a shortened
lamp life, a darkened screen, etc.